Home » 100 Watt Immersion Warmer/Heater (1.5" TC)

100 Watt Immersion Warmer/Heater (1.5" TC)

Out of stock
No sales tax except to FL
Free shipping on orders over $99
Same day processing on most orders
$109.99

Connect this low watt density heating/warming element to any 1.5" tri-clamp port to help keep fermentations warm without scorching during winter months or to increase temperature for pitching of yeast or for diacetyl rest. The stainless steel construction is smooth, sanitary, and easy to clean. Pair with an Inkbird or similar temperature controller to cycle the heating element on and off as needed.

Specs:

100W @ 110-120V 
Total Length: 14"
Length in Conical: 10"
Cord Length: 20"
R
Robby G.
Great temperature control

I have done a few brews with the CF immersion heater and am definitely a fan. I am using a JF8 with an Inkbird thermostat and a Tilt pro hydrometer. The immersion heater has a very sturdy design that makes it feel like it will survive well with regular use and made it easy to clean and sanitize. The size of the heater worked great as it essentially reached to the middle of the JF8. The cable is short but worked well for my setup with the thermostat on the wall right behind the fermenter and made for less cable clutter. The ambient temperature in my garage was about 53° and the heater did a very good job at keeping the internal temperature within two degrees of my set fermentation temperature, 68°. I feel that with the glycol jacket on my fermenter, this heater has added a level up in temperature control. My beers have turned out great. There wasn’t any off flavors and I felt that this heater is a great addition to my setup. I look forward to many great brews in the future.

Proudly Serving Top Brewing & Beverage Companies Nationwide